Hombre XS Space Cab 2WD L4-2.2L CPC (1999)
Control Arm Bushing: Service and Repair
Lower Control Arm
Lower Control Arm Bushings Replacement (RWD)
Removal Procedure
Tools Required
-
J 21474-01 Control Arm Bushing Service Set
-
J 22269-1 Tie Rod End Installer
1. Remove the lower control arm from the vehicle.
2. Install the lower control arm in a vise.
3. Remove the rear bushing.
1. Install J 22269-01 and 21474-8, 12, 13.
2. Tighten until the rear bushing becomes free.
4. Using a blunt chisel, drive the front bushing flare down flush with the rubber part of the bushing.
5. Prior to removing or installing the front bushing, place a wedge or spacer between the control arm bushing housing. This keeps the control arm
bushing housing from bending while removing or installing the bushing.
6. Remove the front bushing.
1. Install J 21474-3,4,5,6. Tighten until the bushing is partially removed.
2. Then, reverse J 21474-6 and tighten until the front bushing becomes free.
Installation Procedure
Tools Required
-
J 21474-01 Control Arm Bushing Service Set
-
J 22269-1 Tie Rod End Installer
