Hombre XS Space Cab 2WD V6-4.3L (1998)
Evaporator Case: Service and Repair
Evaporator Core Assembly
EVAPORATOR CORE
Remove or Disconnect
1. Negative battery cable. Refer to Battery Disconnect Caution in Cautions and Notes.
2. Recover refrigerant from the system. Refer to Refrigerant Recovery.
3. Hood. Refer to Hood Replacement in Sheet Metal.
4. Right fender. Refer to Render Replacement in Sheet Metal.
5. Right front wheel house panel. Refer to Wheel House Panel Replacement in Sheet Metal.
6. Evaporator tube from evaporator. Refer to Evaporator Tube.
7. Accumulator. Refer to Accumulator.
8. Evaporator core assembly heat shield.
9. Electrical connectors/harnesses, as necessary.
10. Blower motor resistor. Refer to Blower Motor Resistor.
-
To access heater core case to bulkhead mounting bolt.
11. Heater core case to bulkhead mounting bolt.
12. Evaporator and blower module screws and nuts.
13. Acoustic barrier, if equipped.
14. Lower right heater core case mounting bolts located at lower right side of instrument panel.
15. With helper lightly pulling the lower right corner of the heater case away from the bulkhead, remove the evaporator core assembly from the
vehicle, 4.3L engine only.
16. Disassemble evaporator core case system.
17. Evaporator core.
Evaporator Core Assembly
Install or Connect
1. Evaporator core.
2. Assemble evaporator core case system.
3. With helper lightly pulling the lower right corner of the heater case away from the bulkhead, install the evaporator core assembly to the vehicle.
4. Lower right heater core case mounting bolts located at lower right side of instrument panel.
5. Acoustic barrier, if equipped.
6. Evaporator core assembly screws and nuts.