Hombre XS Space Cab 2WD V6-4.3L (1998)
Distributor: Service and Repair
Distributor Removal
REMOVAL PROCEDURE
NOTE: If the distributor is removed from the engine, it can be re-installed using Procedure A as long as the crankshaft has not rotated from the original
position. If the intake manifold, the cylinder head, the crankshaft, the camshaft, the timing gear, or the complete engine was removed or replaced,
Procedure B must be followed in order to correctly install the distributor. A DTC code may also indicate an incorrectly installed distributor and engine or
distributor damage may occur. Procedure B must then be used.
1. Turn OFF the ignition switch.
2. Remove the spark plug and the coil leads from the distributor cap.
3. Remove the three-wire hall effect switch connector from the base of the distributor.
4. Remove the two screws holding he cap to the housing.
IMPORTANT: Use a grease pencil in order to not the position of the rotor segment in relation to the distributor housing. Identify the mark with the
number 1.
5. Remove the distributor cap.
6. Remove the mounting clamp hold down bolt.
7. Remove the distributor.
