Hombre XS Space Cab 2WD V6-4.3L (1998)
Step 2: Cut the Wire
Begin by cutting as little wire off the hamess as possible. You may need the extra length of the wire later if you decide to cut more wire off to change the
location of a splice. You may have to adjust splice locations to make certain that each splice is at least 40 mm (1.5 inches) away from other splices,
harness branches, or connectors.
Wire Size Conversion Table
Step 3: Strip the insulation
When replacing a wire, use a wire of the same size as the original wire or larger. The schematics list wire size in metric units. The following table shows
the commercial (AWG) wire sizes that can be used to replace each metric wire size. Each AWG size is either equal to or larger than the equivalent metric
size.
To find the correct wire size either find the wire on the schematic page and convert the metric size to the AWG size, or use an AWG wire gauge.
If you aren't sure of the wire size, start with the largest opening in the wire stripper and work down until a clean strip of the insulation is removed. Be
careful to avoid nicking or cutting any of the wires.
Centering The Splice Clip
