Hombre XS Space Cab 2WD V6-4.3L (1998)
Installation Procedure
1. Install the SDM (2) to the vehicle (3).
2. Install the SDM mounting fasteners (1). Tighten fasteners to 12 N.m (106 lb in). Refer to Fastener Notice in Cautions and Notices.
See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Air Bag(s) Arming and Disarming/Service Precautions/Technician
Safety Information/Fasteners
3. Install the SDM harness connector to the SDM.
4. Install the Connector Position Assurance (CPA) to the SDM harness connector.
5. Position the carpet to cover the supplemental restraint Sensing and Diagnostic Module (SDM).
6. Install the floor console (if equipped).
7. Install the carpet retaining sill trim molding - LH.
8. Install driver seat belt to floor. Refer to Seat Belt Replacement in Seat Belts.
See: Restraint Systems/Seat Belt Systems/Seat Belt
9. Install the driver seat, Refer to Front Seat Replacement in Seats.
10. Enable the SRS. Refer to Enabling the SRS.
See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Air Bag(s) Arming and Disarming
