Hombre XS Space Cab 2WD V6-4.3L (1998)
Steering Wheel Removal
6. Steering wheel using tool J 1859-A and J 42578.
NOTICE: Do not hammer on the steering wheel puller, or damage could result to the steering column.
INSTALL OR CONNECT
IMPORTANT
-
The turn signal lever on the multifunction switch must be in the neutral position when installing the steering wheel.
1. Align the detents on the steering wheel and steering shaft, and install the steering wheel to the shaft.
2. Nut that retains the steering wheel to the steering shaft.
Tighten
-
Nut to 41 Nm (30 ft. lbs.).
3. Steering wheel horn contact.
4. Inflator module. Refer to Inflator Module Replacement. See: Inflator Module Replacement
5. Enable the SRS. Refer to Enabling the SRS. See: Service Precautions
6. Battery negative cable.
CAUTION: Before removing or installing any electrical unit or when a tool or equipment could easily come in contact with "live"
exposed electrical terminals, disconnect the negative battery cable to help prevent personal injury and/or damage to the vehicle or
components. Unless instructed otherwise, the ignition switch must be in the "OFF" or "LOCK" position.
