Hombre XS Space Cab 4WD V6-4.3L (1999)
Dome Lamp Switch
Range: ON/OFF
The BCM uses the dome lamp switch input in determining if the dome lamp switch (thumb wheel) is requesting the interior lights to turn ON.
ON displays if the dome lamp switch requests the BCM to turn the interior lights ON (full up position past the detent).
OFF displays when the dome lamp switch does not request the BCM to turn the interior lights ON (not in the full up position past the detent).
Dome Override Switch
Range: ON/OFF
The BCM uses the dome override switch input from the dome override switch in order to allow or to defeat the interior lighting when the door opens.
The dome override switch is located near the headlamp switch.
ON displays if the dome override switch is overriding the interior lighting.
OFF displays if the dome override switch allows the interior lights to turn ON when any door opens or if the left glass opens (if equipped).
Dim Pot Input
Range: ACTIVE/INACTIVE
The BCM uses the dim pot input in order to determine the position of the dome lamp switch (thumb wheel) when the park lamps are ON.
ACTIVE displays when the dome lamp switch is not in the FULL DOWN position and the park lamps are ON.
INACTIVE displays when you turn the dome lamp switch to the FULL DOWN position (dash lights OFF) and the park lamps are ON.
The headlamp reminder chime does not sound under the following conditions:
-
The dome lamp switch (thumbwheel) is in the FULL DOWN position (MAX DIM).
-
You turn the park lamps ON manually.
-
You remove the ignition key.
Courtesy Lamp Relay
Range: ON/OFF
The BCM uses the courtesy lamp relay input in order to determine the state of the courtesy lamp relay.
ON displays when the BCM commands the courtesy lamps to turn ON by providing a ground for the courtesy lamp relay coil.
OFF displays when the BCM is not commanding the courtesy lamps to turn ON by not providing a ground for the courtesy lamp relay coil.
Auto Headlamps Enable
Range: YES/NO
The output refers to the BCM commanded state of the auto headlamp feature.
YES displays when the BCM commands the auto headlamps to turn ON.
NO displays when the BCM commands the auto headlamps to turn OFF.
Auto Headlamps
Range: ACTIVE/INACTIVE
The BCM uses the auto headlamps input in order to determine if the auto headlamps are ON.
ACTIVE displays when the auto headlamps are ON.
INACTIVE displays when the auto headlamps are OFF.