i-290 2WD L4-2.9L (2008)
*
Illuminates the interior lamps
*
Pulses the horn and flashes the parking lamps for 30 second or until the following conditions occur:
-
The panic button is pressed
-
The ignition switch is turned to the RUN position with a valid key
Rolling Code
The keyless entry system uses rolling code technology. Rolling code technology prevents anyone from recording the message sent from the transmitter
and using the message in order to gain entry to the vehicle. The term "rolling code" refers to the way that the keyless entry system sends and receives the
signals. The transmitter sends the signal in a different order each time. The transmitter and the remote control door lock receiver (RCDLR) are
synchronized to the appropriate order. If a programmed transmitter sends a signal that is not in the order that the RCDLR expects, then the transmitter is
out of synchronization. This occurs after 256 presses of any transmitter button when it is out of range of the vehicle.
Automatic Synchronization
The keyless entry transmitters do not require a manual synchronization procedure. If needed, the transmitters automatically re-synchronize when any
button on the transmitter is pressed within range of the vehicle. The transmitter will operate normally after the automatic synchronization.