i-290 2WD L4-2.9L (2008)
Brake Caliper: Overhaul
Brake Caliper Overhaul
Tools Required
*
J 8092 Universal Driver Handle 3/4 inch-10
*
J 45863 Boot Seal Installer
Caution: Refer to Brake Fluid Irritant Caution (See: Service Precautions/Technician Safety Information/Brake Fluid Irritant Caution) .
Disassembly Procedure
1. Drain all the brake fluid from the caliper.
Caution: Do not place your fingers in front of the piston in order to catch or protect the piston while applying compressed air. This could result in
serious injury.
Important: In the following service procedure, the caliper piston may become damaged when it is removed from the brake caliper
assembly. DO NOT reuse the piston if it becomes damaged. Discard the piston and replace with new.
2. Install the brake caliper in a suitable holding device.
3. Place a piece of wood in the brake caliper in front of the pistons.
4. Cover the brake caliper with a shop towel.
5. Using compressed filtered, non-lubricated air, apply the air to the brake caliper hose inlet port to remove the pistons from the brake caliper.
