i-290 2WD L4-2.9L (2008)
Important: Tilting the crankshaft rear oil seal housing will allow sealer between the housing and the oil pan.
2. Complete the following to install the crankshaft rear oil seal housing:
1. Align the housing with the right alignment dowel, tilting the left side up slightly.
2. Align the housing with the left alignment dowel.
3. Press the housing against the engine block into place.
3. Install the crankshaft rear oil seal housing bolts.
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice).
4. Install the 2 oil pan bolts.
*
Tighten the crankshaft rear oil seal housing bolts to 10 N.m (89 lb in).
*
Tighten the oil pan bolts to 10 N.m (89 lb in).
5. Lightly lubricate the crankshaft rear oil seal lip with clean engine oil.
6. Position the plastic installation sleeve supplied with the new seal to the crankshaft.
