i-290 2WD L4-2.9L (2008)
3. To aid in the installation of the bolts, start a bolt in position (1) first.
Tighten the bolts to 50 N.m (37 lb ft).
4. Lower the engine.
5. Install the engine mount-to-frame bracket through bolt.
Tighten bolts to 85 N.m (63 lb ft).
6. Install the engine coolant pipe bracket bolt from the engine mount. Refer to Heater Outlet Hose Replacement (See: Cooling System/Heater
Hose/Service and Repair/Heater Outlet Hose Replacement).
7. Remove the jack stand.
8. Install the lower intermediate steering shaft. Refer to Lower Intermediate Steering Shaft Replacement (See: Steering and
Suspension/Steering/Steering Column/Service and Repair/Lower Intermediate Steering Shaft Replacement).
9. Install the engine shield, if equipped. Refer to Engine Protection Shield Replacement (See: Body and Frame/Frame/Skid Plate/Service and Repair
).