i-290 2WD L4-2.9L (2008)
Engine Mount: Service and Repair
Engine Mount Replacement - Right Side
Engine Mount Replacement - Right Side
Removal Procedure
1. Remove the wheel and tire assembly. Refer to Tire and Wheel Removal and Installation (See: Maintenance/Wheels and Tires/Service and Repair).
2. Remove the engine shield if equipped. Refer to Engine Protection Shield Replacement (See: Body and Frame/Frame/Skid Plate/Service and
Repair).
3. Support the engine using a jack stand and a block of wood.
4. Remove the engine mount-to-frame bracket through bolt for the mount being replaced.
5. Loosen the left side through bolt.
6. Raise the engine using the jack stand. The engine will tilt to one side.
7. Remove the engine mount bolts.