i-290 2WD L4-2.9L (2008)
Engine Oil: Service and Repair
Engine Oil and Oil Filter Replacement
Removal Procedure
1. Remove the oil fill cap.
2. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle (See: Maintenance/Vehicle Lifting/Service and Repair).
3. Clean any dirt and/or debris away from the oil pan drain plug area.
4. Position a suitable drain pan under the oil pan drain plug.
5. Remove the oil pan drain plug.
6. Allow the oil to drain completely.
7. Clean and inspect the oil pan drain plug, replace if necessary.
8. Clean and inspect the oil pan drain plug sealing surface, replace the oil pan if necessary.
9. Wipe any remaining oil from the drain plug hole and reinstall the oil pan drain plug until snug.
10. Position the container under the engine oil filter drain deflector.
11. Position a suitable drain pan under the oil filter.
