i-290 2WD L4-2.9L (2008)
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice).
Important: Ensure the tensioner release lever is facing outward.
4. Install the balance shaft chain tensioner and bolts.
Tighten the bolts to 10 N.m (89 lb in).
5. Remove the pin holding the tensioner to tighten any slack in the balance shaft drive chain.
6. Verify the correct timing chain and timing mark alignments:
*
The left-hand balance shaft sprocket timing mark (1) is at the 12:00 position.
*
The right-hand balance shaft sprocket timing mark (2) is at the 2:30 position.
*
The crankshaft sprocket timing mark (3) is at the 4:30 position.
*
The 3 timing marks (1-3) on the sprockets line up with a dark link on the chain.