i-290 2WD L4-2.9L (2008)
*
Do not damage the screen located on the air inlet end of the MAF.
*
Do not touch the sensing elements.
*
Do not allow solvents and lubricants to come in contact with the sensing elements.
*
Use a small amount of a soap based solution in order to aid in the installation.
1. Insert the MAF/IAT sensor (2) into the air cleaner assembly.
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice) .
2. Install the MAF/IAT sensor screws (1).
Tighten the screws to 1.5 N.m (13 lb in).
3. Connect the engine wiring harness electrical connector (1) to the MAF/IAT sensor (2).
