i-290 2WD L4-2.9L (2008)
16. Twist together the 2 connector wire leads from the low circuits from both stages of the steering wheel module, to one set of deployment wires.
Refer to Component Connector End Views (See: Diagrams/Connector Views/Component Connector End Views) in order to determine the correct
circuits.
17. Inspect that the 3-wire connection is secure.
18. Bend flat the twisted connection.
19. Secure and insulate the 3-wire connection to the deployment harness using electrical tape.
20. Connect the deployment harness to the connector on the steering wheel module.
21. Route the deployment harness out of the driver side of the vehicle.
22. Disconnect the yellow left roof rail harness connector from the vehicle harness connector.
