i-290 2WD L4-2.9L (2008)
Fuel Tank Pressure Sensor: Service and Repair
Fuel Tank Module Replacement
Fuel Tank Module Replacement
Tools Required
J 45722 Fuel Sender Lock Ring Tool
Removal Procedure
Notice: Clean all of the following areas before performing any disconnections in order to avoid possible contamination in the system:
*
The fuel pipe connections
*
The hose connections
*
The areas surrounding the connections
1. Remove the fuel tank. Refer to Fuel Tank Replacement (See: Powertrain Management/Fuel Delivery and Air Induction/Fuel Tank/Service and
Repair/Removal and Replacement) .
2. Disconnect the evaporative emission (EVAP) line (1) quick connect fittings from the module and the vent valve. Refer to Plastic Collar Quick
Connect Fitting Service (See: Powertrain Management/Fuel Delivery and Air Induction/Fuel Line Coupler/Service and Repair/Plastic Collar
Quick Connect Fitting Service) .
3. Remove the EVAP line from the clip on the side of the fuel tank.
4. Disengage the EVAP line from the retaining features molded into the fuel tank and remove the EVAP line.
5. Disconnect the fuel feed line (2) quick connect fitting from the module. Refer to Plastic Collar Quick Connect Fitting Service (See: Powertrain
Management/Fuel Delivery and Air Induction/Fuel Line Coupler/Service and Repair/Plastic Collar Quick Connect Fitting Service) .
6. Disengage the fuel feed line from the retaining feature molded into the fuel tank and remove the fuel line.
