i-290 2WD L4-2.9L (2008)
Important: Remove the wheel hub and bearing assembly and knuckle as a unit.
10. Remove the knuckle from the upper and lower control arms.
11. Remove the wheel hub and bearing assembly from the knuckle. Refer to Wheel Hub/Speed Sensor Replacement (See: Suspension/Wheel
Hub/Service and Repair) .
Installation Procedure
1. Install the wheel hub and bearing assembly onto the knuckle. Refer to Wheel Hub/Speed Sensor Replacement (See: Suspension/Wheel
Hub/Service and Repair) .
2. Install the lower control arm/ball joint into the knuckle. Refer to Lower Control Arm Ball Joint Replacement (2WD, Z85, ZQ8) (See:
Suspension/Ball Joint/Service and Repair/Lower Control Arm Ball Joint Replacement (2WD, Z85, ZQ8))Lower Control Arm Ball Joint
Replacement (4WD, 2WD Z71) () .
Important: The following service procedure is for vehicles equipped with 4WD only. If the vehicle is not equipped with 4WD, proceed to
Step 4.