i-290 2WD L4-2.9L (2008)
2. Loose install the steering gear horizontal mounting nuts, the washers and the bolts.
3. Install the crossmember, 2WD ONLY. Refer to Crossmember Replacement (See: Suspension/Cross-Member/Service and Repair/Crossmember
Replacement) .
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice) .
4. Loose install the steering gear vertical mounting nuts, the washers and the bolts.
*
Tighten the long bolts to 130 N.m (96 lb ft).
*
Tighten the isolator clamp bolts to 100 N.m (74 lb ft).
5. Install the intermediate shaft to the steering gear.
6. Install the coupler clamp bolt to the intermediate shaft. Refer to Lower Intermediate Steering Shaft Replacement (See: Steering Column/Service
and Repair/Lower Intermediate Steering Shaft Replacement) .
