i-290 2WD L4-2.9L (2008)
5. Install the new nut to the upper ball joint.
Tighten the nuts to 100 N.m (74 lb ft).
6. Connect the wheel speed sensor brackets.
7. Install the wheel speed sensor bracket bolt.
Tighten the nut to 20 N.m (15 lb ft).
8. Connect the front brake hose to the upper control arm. Refer to Front Brake Hose Replacement (See: Brakes and Traction Control/Hydraulic
System/Brake Hose/Line/Service and Repair/Front Brake Hose Replacement) .
9. Remove the support from the lower control arm.
10. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation (See: Wheels and Tires/Service and Repair) .
11. Lower the vehicle.
12. Verify the wheel alignment. Refer to Wheel Alignment Specifications (See: Alignment/Specifications/Wheel Alignment Specifications) .
