i-290 2WD L4-2.9L (2008)
Important: Do not attempt to hold the stabilizer shaft link near the boot. Use the hex feature on the end of the stud. Failure to do so
could damage the boot.
1. Install the stabilizer shaft link.
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice) .
2. Install the stabilizer shaft link mounting nuts.
*
Tighten the stabilizer bar link lower mounting nut to 44 N.m (32 lb ft).
*
Tighten the stabilizer bar link upper mounting nut to 44 N.m (32 lb ft).
3. Remove the axle support.
4. Lower the vehicle.