i-290 2WD L4-2.9L (2008)
2. Pry the clutch master cylinder push rod (1) away from the clutch pedal assembly (2).
Discard the retainer (3).
3. Remove the 4 nuts securing the clutch pedal assembly to the cowl.
4. Remove the clutch pedal assembly from the vehicle.
Installation Procedure
1. Position the clutch pedal assembly over the studs.
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice) .
2. Install the clutch pedal assembly nuts.
Tighten the clutch pedal assembly nuts to 20 N.m (15 lb ft).
