i-290 2WD L4-2.9L (2008)
5. Remove the rear axle fill plug.
6. Inspect the lubricant level.
The lubricant level should be between 0-10 mm (0-0.4 in) below the fill plug opening.
7. If the fluid level is low, add lubricant until the level is within specifications. Use the proper fluid.
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice) .
8. Install the rear axle fill plug.
Tighten the rear axle fill plug to 33 N.m (24 lb ft).
9. Lower the vehicle.