i-290 2WD L4-2.9L (2008)
8. Close the hood.
9. Remove the double layer of masking tape around the perimeter of the painted surfaces and the interior trim.
Windshield Reveal Molding Replacement
Windshield Reveal Molding Replacement
The windshield reveal molding is an applied molding design separate from the window . The reveal molding is bonded to the windshield and may be
bonded to the body. The reveal molding may be replaced with the windshield as an assembly, or the reveal molding may be available as a separate
service part. Refer to Adhesive Installation of Stationary Windows (See: Windows/Service and Repair/Adhesive Installation of Stationary Windows) .
Windshield Side Reveal Molding Replacement
Windshield Side Reveal Molding Replacement
Removal Procedure
1. Open the doors
2. Partially remove the auxiliary weatherstrip (2).
3. Gently pry the reveal molding (1) from the top working towards the air inlet panel.
4. Release the reveal molding from the pinchweld flange.
5. Remove the reveal molding from the windshield pillar.
Installation Procedure
1. Install the reveal molding under the air inlet panel grille.
2. Align the reveal molding to the pinchweld flange and to the top roof header.
3. Press the reveal molding (1) onto the pinchweld flange.
