i-350 L5-3.5L (2006)
1. Position the fascia to the bumper.
*
If the original rear fascia cover is being reused, the tape strips must be replaced in all three areas (1,2,3).
*
Clean all traces of the old tape strips from both fascia and bumper.
*
Clean the upper fascia and lower bumper with a 50/50 mixture of isopropyl alcohol and water by volume on a dampened lint free cloth.
2. Install the top push-in pins to the left and right sides of the upper fascia.
3. Install the top left and right side step pads.
4. Install the center step pads.
5. Raise and support the vehicle. Refer to Vehicle Lifting.
6. Install the push-in pins (4) to the left and right sides, one in each corner of the fascia.
7. Connect the license lamp electrical connectors.
8. Lower the vehicle.
