i-350 L5-3.5L (2006)
4. Remove the tire and wheel assembly.
5. Grasp the brake caliper housing and try to move the brake caliper housing up/down and forward/reverse in relation to the brake caliper mounting
bracket. If excessive looseness is observed the brake caliper bracket bushings and/or the brake caliper mounting bolts may need to be replaced.
6. Compress the front caliper pistons.
6.1.
Install a large C-clamp over the top of the caliper housing and against the back of the outboard pad.
6.2.
Slowly tighten the C-clamp until the pistons are pushed completely into the brake caliper bores.
6.3.
Remove the C-clamp from the brake caliper.
7. With the pistons compressed into the caliper bores, grasp the brake caliper housing and slide it back and forth on the brake caliper mounting bolts.
Check for smooth operation. If the brake caliper housing slide force is high or the brake caliper housing does not slide smoothly, inspect the brake
caliper mounting bolts and/or the brake caliper mounting bracket bushings for wear or damage. It wear or damage conditions are found,
replacement of the brake caliper mounting bolts and/or the brake caliper mounting bracket bushings is necessary.
8. Remove the brake caliper mounting bracket. Refer to Brake Caliper Bracket Replacement.
9. Inspect the disc brake pad mounting hardware for the following conditions:
^
Missing mounting hardware
