i-350 L5-3.5L (2006)
coating from the brake pipe until the metal pipe surface is exposed.
^
Loosen the thumbwheel of the tool and remove the brake pipe.
Important: Ensure that all loose remnants of the nylon coating have been removed from the brake pipe.
^
Inspect the stripped end of the brake pipe to ensure that the proper amount of coating has been removed.
^
6.35 mm (0.250 in) for 4.76 mm (3/16 in) diameter pipe
^
9.50 mm (0.374 in) for 6.35 mm (1/4 in) diameter pipe
16. Chamfer the inside and outside diameter of the pipe with the de-burring tool included in the J 45405.
17. Install the tube nuts on the brake pipe, noting their orientation.
18. Clean the brake pipe and the J 45405 of lubricant, contaminants, and debris.
19. Loosen the die clamping screw of the J 45405.
20. Select the corresponding die set and install the die halves into the die cage with the full, flat face of one die facing the clamping screw, and the
counterbores of both dies facing the forming ram.
