i-350 L5-3.5L (2006)
10. Remove the exhaust camshaft position actuator.
11. Clean and inspect the sprocket. Refer to Timing Chain and Sprockets Cleaning and Inspection.
Installation Procedure
1. Ensure the camshaft actuator is fully advanced prior to installation.
2. Install the exhaust camshaft actuator into the timing chain.Aligning the marked link (1) on the timing chain with the timing mark (1) on the exhaust
camshaft position actuator sprocket.
3. Notice: The camshaft actuator must be fully advanced during installation. Engine damage may occur if the camshaft actuator is not fully
advanced.
Important:
^
To aid in aligning the actuator to the camshaft, use a 25 mm (1 inch) wrench on the hex of the camshaft to rotate
^
Ensure the alignment pin is properly engaged with the camshaft
Install the exhaust camshaft actuator onto the exhaust camshaft.
4. Notice: Refer to Fastener Notice in Service Precautions.
Install the new exhaust camshaft actuator bolt.
1
Tighten the exhaust camshaft actuator bolt to 25 Nm (18 ft. lbs.).
2
Use the J 45059 to rotate the exhaust camshaft actuator bolt an additional 135 degrees.
