i-350 L5-3.5L (2006)
1. Install the SDM (1) to the floor studs (3) with 3 nuts (2).
Tighten the SDM nuts to 9 N.m (79 lb in).
NOTE: Refer to Fastener Notice in Service Precautions.
2. Connect the electrical connector (2) to the SDM (1).
3. Fold the carpet back down over the SDM.
4. Install the floor console.
5. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 8.
IMPORTANT: The AIR BAG indicator may remain ON after the SDM has been replaced. DTC B1001 may set requiring the SDM part number to
be set in multiple modules. If the indicator remains ON after enabling the SIR system, perform the diagnostic system check and follow the steps
thoroughly to ensure that the SDM is set properly.
6. Program the SDM. Refer to Control Module References in Computer/Integrating Systems.
