i-350 L5-3.5L (2006)
10. Remove the 2 side retaining nuts (1) from the PSIR module.
11. Partially remove the PSIR inflator module from the I/P.
12. Disconnect the connector position assurance (CPA).
13. Disconnect the electrical connector from the PSIR module.
14. Remove the PSIR inflator module from the vehicle.
15. Fully deploy the module before disposal. If the module is being replaced under warranty, fully deploy and dispose of the module after the required
retention period. Refer to Inflator Module Handling and Scrapping.
16. If replacing the PSIR bracket, remove the I/P assembly.
IMPORTANT: If the PSIR module has deployed while attached to the I/P, the PSIR bracket MUST be replaced.
