i-350 L5-3.5L (2006)
4. Position the J 41364-A onto the park/neutral back up switch. Ensure that the 2 slots on the switch where the manual shaft is inserted are lined up
with the lower 2 tabs on the tool.
5. Notice: Refer to Fastener Notice in Service Precautions.
Rotate the switch until the upper locator pin on the tool is lined up with the slot on the top of the switch.
^
Tighten the park/neutral back up switch bolts 27 Nm (20 ft. lbs.).
6. Remove the J 41364-A from the switch. If installing a new switch, remove the positive assurance bracket at this time.
7. Connect the electrical connector (3) to the switch (4).
