i-350 L5-3.5L (2006)
7. Pressing the J 38125-12A (GM P/N 12094429) tool in the release cavity of the terminal you are removing, gently pull the wire out of the back of
the connector. Always remember never use force when pulling a terminal out of a connector. See the release tool cross reference in the Reference
Guide of the J 38125-D to ensure that the correct release tool is used.
TERMINAL REPAIR PROCEDURE
Use the appropriate terminal and crimper in the J 38125 in order to replace the terminal.
Tyco/Amp Connectors (Sensor)
TYCO/AMP CONNECTORS (SENSOR)
TOOLS REQUIRED
J 38125Terminal Repair Kit
TERMINAL REMOVAL PROCEDURE
1. Disconnect the connector from the component.
2. Insert the J 38125-11A (GM P/N 12094430) tool into the cavity on the lower right hand face of the connector until the terminal release tang access
panel slides over.
