i-350 L5-3.5L (2006)
10. Remove the 2-4 servo from the transmission.
11. Inspect the 4th apply piston, 2-4 servo converter, 2nd apply piston, and the servo piston inner housing for the following defects.
^
Cracks
^
Scoring
^
Burrs and nicks
12. Disassemble the 2-4 servo if necessary. Refer to 2-4 Servo Disassemble in Automatic Transmission-4L60-E/4L65-E Unit Repair.
13. Clean and inspect the 2-4 servo. Refer to 2-4 Servo Pin Length Check in Automatic Transmission-4L60-E/4L65-E Unit Repair.
Installation Procedure
1. Assemble the 2-4 servo if previously disassembled. Refer to 2-4 Servo Assembly Installation in Automatic Transmission-4L60-E/4L65-E Unit
Repair.
2. Lightly lubricate the seals with clean transmission fluid.
3. Install new seals on the servo pistons and the servo cover.
4. Install the 2-4 servo assembly into the transmission.
5. Install the J 29714-A to the transmission oil pan flange.
6. Tighten the bolt in order to compress the servo cover.
7. Install the servo cover retaining ring.
8. Remove the J 29714-A.
9. Notice: Refer to Fastener Notice in Service Precautions.
Install the oil pan bolt.
^
Tighten the oil pan bolt to 11 Nm (97 inch lbs.).
10. Install the front propeller shaft (4WD only).
11. Lower the vehicle.
