i-350 L5-3.5L (2006)
Fluid Pressure Sensor/Switch: Service and Repair
Valve Body and Pressure Switch Replacement
Removal Procedure
1. Ensure that removal of the valve body is necessary before proceeding.
Important: The following components can be serviced without removing the valve body from the transmission:
The torque converter clutch (TCC) solenoid (1)
^
The pressure control solenoid (2)
^
The internal wiring harness (3)
^
The 2-3 shift solenoid (4)
^
The 1-2 shift solenoid (5)
^
The transmission fluid pressure (TFP) manual valve position switch (6)
^
The 3-2 shift solenoid (7)
^
The torque converter clutch pulse width modulation (TCC/PWM) solenoid (8)
2. Remove the fluid level indicator.
3. Remove the oil pan, and filter. Refer to Automatic Transmission Fluid/Filter Replacement.
4. Disconnect the internal wiring harness electrical connectors from the following components:
^
The TFP manual valve position switch (1)
^
The 1-2 shift solenoid (2)
^
The 2-3 shift solenoid (3)
^
The pressure control solenoid (4)
^
The TCC/PWM solenoid (5)
^
The 3-2 shift solenoid (6)
