i-350 L5-3.5L (2006)
16. Tighten the pinion nut while holding the J 8614-01.
^
Tighten the pinion nut until the pinion end play is just taken up. Rotate the pinion while tightening the nut to seat the bearings.
17. Measure the rotating torque of the pinion using an inch-pound torque wrench.
^
The rotating torque of the pinion should be 1.0 - 2.3 Nm (10 - 20 inch lbs.) for used bearings, or 1.7 - 3.4 Nm (15 - 30 inch lbs.) for new
bearings.
18. If the rotating torque measurement is below 1.0 Nm (10 inch lbs.) for used bearings, or 1.7 Nm (15 inch lbs.) for new bearings, continue to
tighten the pinion nut.
^
Tighten the pinion nut, in small increments, as needed, until the torque required in order to rotate the pinion is 1.0 - 2.3 Nm (10 - 20 inch lbs.)
for used bearings, or 1.7 - 3.4 Nm (15 - 30 inch lbs.) for new bearings.
19. Once the specified torque is obtained, rotate the pinion several times to ensure the bearings have seated.
Recheck the rotating torque and adjust if necessary.
20. Install the differential carrier assembly.
21. Lower the vehicle.
