i-350 L5-3.5L (2006)
2. Important: Ensure the seal does not catch on the input shaft splines.
Position the input shaft bearing retainer to the transmission.
3. Apply pipe sealant GM P/N 12346004 (Canadian P/N 10953480) to the threads of the input shaft bearing retainer bolts if new bolts are not
available.
4. Notice: Refer to Fastener Notice in Service Precautions.
Install the NEW input shaft bearing retainer bolts.
^
Tighten the input shaft bearing retainer bolts to 17 Nm (13 ft. lbs.).
5. Install the clutch actuator cylinder.
6. Fill the transmission fluid.
