i-350 L5-3.5L (2006)
3. Disconnect the gray 2/4 indicator switch electrical connector (2) from the bracket (1).
4. Loosen the switch connector bracket bolt in order to release the 2/4 indicator switch pigtail.
5. Remove the transfer case 2/4 indicator switch (4) and gasket (3) from the transfer case.
Installation Procedure
1. Notice: Refer to Component Fastener Tightening Notice in Service Precautions.
Install the transfer case 2/4 indicator switch (4) and gasket (3) into the transfer case.
Tighten the 2/4 indicator switch to 39 Nm (29 ft. lbs.).
2. Route the 2/4 indicator switch pigtail along the bracket (1)
3. Install the switch connector bracket bolt.
Tighten the switch connector bracket bolt to 15 Nm (11 ft. lbs.).
4. Connect the gray 2/4 indicator switch electrical connector (2) to the bracket (1).