i-370 4WD L5-3.7L (2007)
8. Install the SIR fuse to the fuse block (1) located in the underhood fuse block.
9. Staying well away from all air bags, turn ON the ignition, with the engine OFF.
9.1.The AIR BAG indicator will flash 7 times.
9.2.The AIR BAG indicator will then turn OFF.
10. Perform the Diagnostic System Check - SIR if the AIR BAG indicator does not operate as described.
SIR Disabling and Enabling Zone 3
SIR Disabling and Enabling Zone 3
Disabling Procedure
IMPORTANT: Refer to SIR Disabling and Enabling Zones before disabling the SIR system.
1. Turn the steering wheel until the vehicle's wheels are pointing straight ahead.
2. Turn OFF the ignition.
3. Remove the key from the ignition.
4
Remove the trim panel.
IMPORTANT: With the SIR fuse removed and the ignition ON, the AIR BAG indicator illuminates. This is normal operation and does not
indicate an SIR system malfunction.
5. Remove the SIR fuse from the fuse block (1) located in the underhood fuse block.
6. Remove the connector position assurance (CPA) (1) from the steering wheel module yellow 4-way connector (2) located left of the steering
column above the left hinge pillar trim panel.
7. Disconnect the steering wheel module yellow 4-way connector (2) located left of the steering column above the left hinge pillar trim panel.
