Oasis LS L4-2156cc 2.2L SOHC MFI F22B6 (1997)
5. Measure taper at the edges of each journal.
-
The difference between measurements on each journal must not exceed the standard.
-
Journal Taper
-
Standard (New): 0.005 mm (0.0002 inch)
6. Measure runout on the No. 2 journal of each balancer shaft to make sure the balancer shafts are not bent.
-
Balancer Shaft Total Indicated Runout
-
Standard (New): 0.02 mm (0.001 inch)
-
Service Limit: 0.03 mm (0.001 inch)
7. Measure the diameters of the balancer shaft journals.
