Oasis LS L4-2156cc 2.2L SOHC MFI F22B6 (1997)
Air Bag Control Module: Service and Repair
CAUTION
^
Before disconnecting any part of the SRS main harness, disconnect the airbag connectors.
^
During installation or replacement, do not bump (impact wrench, hammer etc.) the area near the SRS unit
^
Do not damage the SRS unit terminals or connectors.
^
Do not disassemble the SRS unit; it has no service able parts.
^
Store the SRS unit in a clean, dry area.
^
Do not use any SRS unit which has been subjected to water damage or shows signs of being dropped or improperly handled, such as dents, cracks
or deformation.
1. Make sure you have the anti-theft code for the radio, then write down the frequencies for the radio's preset buttons.
2. Disconnect the battery negative cable, then disconnect the positive cable from the battery, and wait at least three minutes.
Disconnecting the Airbag Connectors
Front Passenger's Airbag Connectors / SRS Main Harness
3. Disconnect the airbag connectors.
4. Remove both heater lower covers from the center console.
