Oasis LS L4-2156cc 2.2L SOHC MFI F22B6 (1997)
Air Bag(s) Arming and Disarming: Service and Repair
General Precautions
^
Carefully inspect any Supplemental Restraint Systems (SRS) part before you install it. Do not install any part that shows signs of being dropped or
improperly handled, such as dents, cracks or deformation:
^
Use only a digital Multimeter to check the system. If it's not a Honda Multimeter, make sure its output is 10 mA (0.01 A) or less when switched to
the smallest value in the ohmmeter range. A tester with a higher output could damage the airbag circuit or cause accidental deployment and
possible injury.
^
Do not install used SRS parts from another vehicle. When making SRS repairs, use only new parts.
^
Except when performing electrical inspections, always disconnect both the negative cable and positive cable from the battery, and wait at least
three minutes before beginning work.
^
Replacement of the combination light and wiper/ washer switches and cruise control switch can be done without removing the steering wheel:
-
Combination light and wiper/washer switch replacement.
-
Cruise control set/resume switch replacement.
^
Whenever the ignition switch is ON (II), or has been turned OFF for less than three minutes, be careful not to bump the SRS unit; the airbags
could accidentally deploy and cause damage or injuries.
^
Whenever the airbag has been activated, replace the SRS unit.
^
The original radio has a coded theft protection circuit. Be sure to get the customer's code number before disconnecting the battery cables.
