Oasis LS L4-2156cc 2.2L SOHC MFI F22B6 (1997)
40. Install the special tool onto the end of the steering rack, then coat the special tool with power steering flair
41. Coat the inside surface of the new cylinder end seal with power steering fluid.
42. Install the cylinder end seal onto the steering rack with its grooved side toward the piston.
43. Remove the special tool. Push in the cylinder end seal with your finger.
NOTE: Take care not to damage the cylinder end seal with the threads and burrs at the staked position of the gearbox.
44. Install the special tool to the steering gearbox, then clamp the tool in a vise with soft jaws as shown.
CAUTION: Do not clamp the cylinder housing.
45. Grease the inside surface of the cylinder end, then install the cylinder end into the cylinder housing. Tighten the cylinder end to the specified
torque.
46. Remove the tool from the steering gearbox.
47. After tightening the cylinder end, stake the point of the cylinder housing shown below.
NOTE: Stake the cylinder in the position opposite from where the stake was removed during disassembly.
48. Select the 32 mm shim(s).
NOTE: Only reinstall the original 32 mm shim(s) when the steering gearbox is reassembled without replacing the pinion shaft, valve housing, and
gearbox housing with new ones. If the pinion shaft, valve housing, and gearbox housing are replaced, select the new shim(s) as follows.
