Oasis LS L4-2253cc 2.3L SOHC VTEC MFI (1999)
Air Bag(s) Arming and Disarming: Service and Repair
Improper Handling Of Airbag Assembly
-
Carefully inspect any SRS part before you install it. Do not install any part that shows signs of being dropped or improperly handled, such as
dents, cracks or deformation:
-
Airbag assemblies
-
Cable reel
-
SRS unit
-
Use only a digital multimeter to check the system. If it's not a Honda multimeter, make sure its output is 10 mA (0.01 A) or less when switched to
the smallest value in the ohmmeter range. A tester with a higher output could damage the airbag circuit or cause accidental deployment and
possible injury.
-
Do not install used SRS parts from another vehicle. When making SRS repairs, use only new parts.
-
Except when performing electrical inspections, always disconnect both the negative cable and positive cable from the battery, and wait at least
three minutes before beginning work.
-
Replacement of the combination light and wiper washer switches and cruise control switch can be done without removing the steering wheel:
*
Combination light and wiper/washer switch replacement.
*
Cruise control set/resume switch replacement.
--
Whenever the ignition switch is ON, or has been turned OFF for less than three minutes, be careful not to bump the SRS unit; the airbags could
accidentally deploy and cause damage or injury.
-
Whenever the airbag has been activated, replace the SRS unit.
-
The original radio has a coded theft protection circuit. Be sure to get the customer's code number before disconnecting the battery cables.
