Oasis LS L4-2253cc 2.3L SOHC VTEC MFI (1999)
Ignition Coil: Testing and Inspection
1. Turn the ignition switch OFF, and remove the distributor ignition (DI) cap.
2. Remove the two screws to disconnect the BLK/YEL and WHT/BLK wires from terminals A (+) and B (-) respectively.
3. Using an ohmmeter, measure resistance between the terminals. Replace the coil if the resistance is not within specifications.
NOTE: Resistance will vary with the coil temperature; specifications are at 68° F (20° C)
Primary Winding Resistance
(Between the A and B terminals):
0.45-0.6 Ohms
Secondary Winding Resistance
(Between the A and secondary winding terminals):
22-34 kOhms
