Oasis LS L4-2253cc 2.3L SOHC VTEC MFI (1999)
Sensing And Diagnostic Module: Service and Repair
CAUTION:
- Before disconnecting any part of the SRS wire harness, disconnect the airbag connectors.
- During installation or replacement, do not bump (impact wrench, hammer etc.) the area near the SRS unit.
NOTE:
- Do not damage the SRS unit terminals or connectors.
- Do not disassemble the SRS unit; it has no serviceable parts.
- Store the SRS unit in a clean, dry area.
- Do not use any SRS unit which has been subjected to water or shows signs of being dropped or improperly handled, such as dents, cracks or
deformation.
1. Disconnect the battery negative cable, then disconnect the positive cable from the battery, and wait at least three minutes.
2. Disconnect the airbag connectors.
NOTE: When disconnected, the airbag connectors are automatically shorted.
Driver's Side
Remove the access panel from the steering wheel, then disconnect the 2P connector between the driver's airbag and cable reel.
Front Passenger's Side
Remove the dashboard compartment, then disconnect the 2P connector between the front passenger's airbag and SRS the main harness.
3. Remove both heater lower covers from the center console.
Heater Upper / Lower Covers
4. Disconnect the SRS main harness 18P connector from the SRS unit.