Oasis LS L4-2253cc 2.3L SOHC VTEC MFI (1999)
9. Remove the brake disc from the knuckle.
10. Check the front hub for damage and cracks.
11. Remove the wheel sensor wire bracket, then remove the wheel sensor from the knuckle (with ABS).
NOTE:
-
Do not disconnect the wheel sensor connector.
-
Use the special tool to separate the ball joints from the suspension or tie-rod end.
CAUTION: Be careful not to damage the ball joint boot.
12. Clean any dirt or grease off the ball joint.
13. Remove the cotter pin from the tie-rod end ball joint 10 mm nut, and loosen the nut.
14. Apply grease to the special tool on the areas shown. This will ease installation of the tool and prevent damage to the pressure bolt threads.
15. Install the special tool as shown. Insert the jaws carefully, making sure you do not damage the ball joint boot.
16. Adjust the jaw spacing by turning the pressure bolt.
NOTE: If necessary, apply penetrating type lubricant to loosen the ball joint.
