Oasis LS L4-2253cc 2.3L SOHC VTEC MFI (1999)
1. Install the knuckle on the driveshaft outboard joint.
2. Install the knuckle on the tie-rod end, upper arm and lower arm, then tighten the castle nuts and install the new cotter pins.
CAUTION: Torque the castle nut to the lower torque specification, then tighten it only far enough to align the slot with the pin hole. Do not align
the nut by loosening.
3. Install the wheel sensor with the sensor mounting bolts (with ABS).
4. Install the wheel sensor wire bracket with the two flange bolts (with ABS).
NOTE: Be careful when installing the sensors to avoid twisting wires.
