Oasis LS L4-2253cc 2.3L SOHC VTEC MFI (1999)
WARNING: Lower arm B is under spring pressure. When installing lower arm B, refer to spring installation.
CAUTION:
-
Any bolts or nuts connected to rubber mounts or bushings should be tightened with the vehicle on the ground.
-
Torque the castle nut to the lower torque specification, then tighten it only far enough to align the slot with the pin hole. Do not align the nut by
loosening.
-
When removing the knuckle or suspension arms, adjust the load sensing proportioning valve (LSPV) after installing the removed parts.
NOTE:
-
Wipe off any oil, dirt or grease from the threads before tightening the fasteners.
-
Make sure the toe adjuster cams on lower arm B are installed in the same direction.
-
The right and left lower arm B are not interchangeable. Install so the welded nut faces toward the front.
-
After installing the suspension arm, check the rear wheel alignment, and adjust if necessary.
