Oasis S L4-2253cc 2.3L SOHC VTEC MFI (1998)
Airbag Deployment and Disposal (Inside Vehicle)
Before scrapping any airbags (including those in a whole vehicle to be scrapped), the airbags must be deployed. If the vehicle is still within the warranty
period, before you deploy the airbags, the Honda District Service Manager must give approval and/or special instructions. Only after the airbags have
been deployed (as the result of vehicle collision, for example), can they be scrapped.
If the airbags appear intact (not deployed), treat them with extreme caution.
Follow this procedure:
Deploying the Airbags: In-vehicle
If an SRS vehicle is to be entirely scrapped, its airbags should be deployed while still in the vehicle. The airbags should not be considered as salvageable
parts and should never be installed in another vehicle.
WARNING: Confirm that each airbag is securely mounted; otherwise, severe personal injury could result from deployment.
1. Disconnect the battery negative cable, then disconnect the positive cable.
2. Confirm that the special tool is functioning properly by following the check procedure on the tool label.
Driver's Airbag
Driver's Airbag / Cable Reel Connector
3. Remove the access panel, then disconnect the 2P connector between the driver's airbag and the cable reel.
Front passenger's Airbag
Front Passenger's Airbag / SRS Main Harness
4. Remove the dashboard compartment, then disconnect the 2P connector between the front passenger's airbag and the SRS main harness.
