Oasis S L4-2253cc 2.3L SOHC VTEC MFI (1998)
Deploying the Airbag: Out-of-vehicle
If an intact airbag has been removed from a scrapped vehicle, or has been found defective or damaged during transit, storage or service, it should be
deployed as follows:
1. Confirm that the special tool is functioning properly by following the check procedure.
2. Position the airbag face up, outdoors on flat ground at least thirty feet (10 m) from any obstacles or people.
3. Cut off the airbag connector, strip the ends of the airbag wires, and connect the deployment tool alligator clips to the airbag. Place the deployment
tool at least thirty feet (10 meters) away from the airbag.
4. Connect a 12 volt battery to the tool
-
If the green light on the tool comes on, the airbag igniter circuit is defective and cannot deploy the airbag. Go to Damaged Airbag Special
Procedure.
-
If the red light on the tool comes on, the airbag is ready to be deployed.
5. Push the tool's deployment switch. The airbag should deploy (deployment is both highly audible and visible; a loud noise and rapid inflation of the
bag, followed by slow deflation).
-
If the airbags deploy and the green light on the tool comes on, continue with this procedure.
-
If an airbag doesn't deploy, yet the green light comes ON, its igniter is defective. Go to Damaged Airbag Special Procedure.
-
During deployment, the airbag can become hot enough to burn you. Wait thirty minutes after deployment before touching the airbag.
6. Dispose of the complete airbag. No part of it can be reused. Place it in a sturdy plastic bag, and seal it securely.
CAUTION:
-
Wear a face shield and gloves when handling a deployed airbag.
-
Wash your hands and rinse them well with water after handling a deployed airbag.
Deployed Air Bag Handling
When handling a deployed air bag assembly, a face shield and rubber gloves should be worn. Vehicle interior and A/C, vent, defroster and heater ducts
should be vacuumed. If sinus or throat irritation is encountered during air bag removal, exit vehicle and breathe fresh air. If skin irritation is encountered,
flush effected area with cool water. If sinus, throat, skin or any other type of irritation continues, consult a physician. After handling a deployed air bag
assembly, wash hands and rinse thoroughly with water.
An air bag that has been deployed should be removed from the vehicle. Prior to removing a deployed air bag assembly, place tape over air bag exhaust
vents. After unit has been removed, it should be placed in a heavy duty plastic bag and sealed securely. The sealed plastic bag should then be placed with
automotive scrap. An air bag assembly that has not been deployed, must be deployed prior to disposal.
